Plywood Oak Crown Cut Veneer

Ordering customised Plywood Oak Crown Cut Veneer boards online

Order cut-to-size Plywood Oak Crown Cut Veneer easily online. Veneered Plywood can be cut to size down to the millimetre. We deliver the panel fully custom-made to your home. Are you curious about the possibilities? Configure your product and you will have your project ready in no time.

Plywood Oak Crown Cut Veneer: what is it?

Plywood panels are boards constructed from 3 layers. In this case, a core of hardwood and a top layer of oak crown cut veneer. This thin board material can be used well alongside other oak crown cut veneer panels. Because it is thin, the stronger hardwood was chosen instead of MDF in this case. One property of hardwood is that it can warp. Because it is thin board material, it is important to mount these panels properly.

Plywood Oak Crown Cut Veneer, sheet material with a natural surface layer

Unlike melaminated board material, the top layer of veneered panels is a layer of real wood. This gives the material a calm, natural look. Because it is a natural product, there may be colour and texture differences between different panels. No two panels are the same. In addition, it is important that this panel is finished with a lacquer or oil as desired. This prevents discolouration and preserves the top layer. 

Crown cut or Quartered veneer

Cutting logs is usually done in two different ways: crown / plain or kwartiers. When the wood is cut crown / plain, long slices are cut lengthwise. This allows the flames of the material to be clearly seen and makes the best use of the wood. When the wood is kwartiers} cut, it is cut with the grain. This gives kwartiers sawn timber a calm appearance and relatively straight lines. In mix, these two techniques are processed interchangeably and used during the compilation of the veneer. This creates a natural whole and makes each slab unique.

Available thicknesses of Plywood Oak Crown Cut Veneer

With us, you order high-quality veneered plywood made to measure and in various thicknesses. You can easily specify the desired thickness in the product configurator. This ensures that the plywood meets your requirements in terms of both size and thickness. The following thicknesses are available: 4.6 mm.

Processing Plywood Oak Crown Cut Veneer boards

This sheet material is easy to work with. Make sure you have sharp tools to minimise splintering. For drilling holes, we recommend a wood drill with a centre point. Pre-drilling is recommended, but not necessary. This board material may discolour over time, so finish it with a (clear) lacquer, stain or paint. Use an edge sealer to finish the edges of the plywood, this will prevent the lacquer or stain from soaking into the plywood, which could lead to the veneer layers coming loose.

Specific applications of veneered oak

Triplex is very suitable for joinery and decorative applications such as cabinets or other furniture. Depending on the thickness of the board material, it is important to assemble the panels properly. In that case, they are suitable for any finishing application you have in mind.

Alternatives for Plywood Oak Crown Cut Veneer

Is Plywood Oak Crown Cut Veneer not the right type of wood for your job after all? Looking for other board material with a grain? Then go for poplar plywood. Do you want boards that can be used outdoors? Check out phenolic plywood, MDF tricoya or multiplex okoume. Or see our other veneered panel here: